Cruise仿真报错:ERROR M_237 : Vehicle: Data Bus Input 'x-Axis for Drag Coefficient' not connect
ERROR M_237 : Vehicle: Data Bus Input 'x-Axis for Drag Coefficient' not connected
ERROR M_237 : Vehicle: Data Bus Input 'x-Axis for Drag Coefficient' not connected
WARNING M_236 : The shifting program selector is outside of desired shifting programs
ERROR M_235 : Option 'Power Loss' is only allowed to be used with Characteristic Maps and Curves 'Overall'
WARNING M_234 : No Driveability Index in DRIVE for export selected
ERROR M_233 : Gear Box Program: Data Bus Input 'Shifting Program Selector' not connected
WARNING M_232 : The corresponding shifting program is not activated for the shifting control value
ERROR M_231 : Cylinder cut-out Control: Data Bus Input 'Gear position' not connected
ERROR M_230 : Cylinder cut-out Control: Data Bus Input 'Current Transmission Ratio' not connected
WARNING M_229 : Slip in task activated, but in wheel deactivated
ERROR M_228 : The ascending gradient in the Altitude Curve is greater than the corresponding covered distance
WARNING M_227 : Cannot retrieve KULI major version number. Default value is ...
WARNING M_226 : KULI : Com Output Object does not exist
WARNING M_225 : Engine: Data Bus Input 'External Cut-Off Signal from Data Bus' connected, but associated setting in engine's drop-down list not chosen
ERROR M_224 : Engine: Data Bus Input 'External Cut-Off Signal from Data' bus not connected
ERROR M_223 : AMT Control: Data Bus Input 'external Launching Clutch Release' not connected
ERROR M_222 : AMT Control: Data Bus Input 'external Launching Clutch Release' not connected
ERROR M_221 : DCT Control: Shifting gear- and load dependent: incorrect input data of Gears
ERROR M_220 : DCT Control: Data Bus Input 'Desired Torque' not connected
ERROR M_219 : DCT Control: Data Bus Input 'Load Signal' not connected
ERROR M_218 : AMT Control: Data Bus Input 'Desired Torque' not connected
ERROR M_217 : AMT Control: Data Bus Input 'Load Signal' not connected
ERROR M_216 : DCT Control: Switch not activated for Launching Clutch Release from Data Bus
ERROR M_215 : AMT Control: Switch not activated for Launching Clutch Release from Data Bus
WARNING M_213 : Profile improvement AND driver foresight both activated => foresight gets priority
WARNING M_211 : Clutch Program: actual gear is higher than the defined gears
© Copyright 2012-2142 www.Avl-Cruise.com Some rights reserved. 皖ICP备15024617号-5